MSP-FET430U64F: MSP-FET430 Red Led always on, no programming

Felipe Garay

Part Number: MSP-FET430U64F
Other Parts Discussed in Thread: MSP-FET

Hello experts.

I'd like to ask if anyone have solved this issue:

Just when I connect my JTAG to my computer (or any computer) the green light turns on, and after 2 o 3 seconds, the red light turns on and stays on. When I try to program my microcontroller it always says: Unknown device.

Has anyone solved this issue?

Thank you in advance.

over 1 year ago

0 Cash Hao11 over 1 year ago

TI__Mastermind 39235 points

Hi,

According to this guide, table 7. https://www.ti.com/lit/ug/slau647o/slau647o.pdf

And if this still not helping. You can try the chapter 5.6.5.3 MSP-FET HID Cold Boot.

Best regards,

Cash Hao

0 Felipe Garay 12 months ago in reply to Cash Hao11

Prodigy 110 points

Hi Cash Hao11, I've already tried what you've suggested, but I'm still having the same issue. Is there any other option I could try?

0 Cash Hao11 12 months ago in reply to Felipe Garay

TI__Mastermind 39235 points

Hi,

Sorry for the late response. Just back to the office due to the holiday here.

Maybe the issue is caused by the target board consumes too much current and the MSP-FET can not provide that current. You can try using an external voltage supplier for the target board for a workaround.

Best regards,

Cash Hao

0 Felipe Garay 12 months ago in reply to Cash Hao11

Prodigy 110 points

Great! I´ll check that out, and then comment results. Thank you!

0 Cash Hao11 12 months ago in reply to Felipe Garay

TI__Mastermind 39235 points

Ok, let me know if you need more help.

Best regards,

Cash Hao

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP-FET430U64F: MSP-FET430 Red Led always on, no programming