MSP430AFE221: MSP430 PAM board on ADS1115 EVM

Stan woldes

Part Number: MSP430AFE221
Other Parts Discussed in Thread: ADS1115, MSP432E401Y, MSP-EXP432E401Y

Hi I would like to know if the msp430 PAM board found on ADS1115 EVM be use to program like a normal TIVA TM4C123G MCU EVM board? Saw this on SBAU362 PAGE1

over 2 years ago

0 Cash Hao11 over 2 years ago

TI__Mastermind 46765 points

Hi,

I think you can program msp430 MCU. But this board should made by ADS team. You might need to confirm with them.

Best regards,

Cash Hao

0 Stan woldes over 2 years ago in reply to Cash Hao11

Prodigy 180 points

hi, can you help to direct to ADS team ?

0 Bob Benjamin over 2 years ago in reply to Stan woldes

TI__Guru** 113765 points

Hi Stan,

The PAMB is a motherboard for PADC EVMs and is not a development platform nor will it be supported as such. It is possible to reprogram the MCU on the PAMB (MSP432E401Y) but this is not a supported function.

If developing code, it would be easier to use the MSP-EXP432E401Y LaunchPad which also includes a debugger interface.

Best regards,

Bob B

0 Stan woldes over 2 years ago in reply to Bob Benjamin

Prodigy 180 points

Hi Bob, the ADS1115 EVM was fine for a week, today it is not, LED light on left side of PAM board is not ON when power up with attached USB micro cable. please help..

0 Bob Benjamin over 2 years ago in reply to Stan woldes

TI__Guru** 113765 points

Hi Stan,

Either the board is not getting power or the firmware has been corrupted. From Device Manager, how is the board being identified? If nothing is showing, you may have a poor connection at the USB connector.

Bests regards,

Bob B

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430AFE221: MSP430 PAM board on ADS1115 EVM