MSP430F6779A: GPIO

Darvin R

Part Number: MSP430F6779A

Tool/software:

Hi TI,
For this GPIO pin open drain or push-pull driver?In this datasheet details not available,how to find?

0 David Schultz over 1 year ago

Guru 26085 points

GPIOs are push/pull.

The I2C module will alter that to open drain for SDA and SCL when it is in control.

+1 Darvin R over 1 year ago in reply to David Schultz

Hi david schultz,

Thanks for your reply,please let me know how to say push-pull any rule of thumb?where did you find?

0 Diego Abad Sajamin over 1 year ago in reply to Darvin R

Hi Darvin,
You can find the information in the MCU datasheet on page 79 under Table 6-12. Default Port Mapping.

Best Regards,

Diego Abad

**Attention** This is a public forum

MSP low-power microcontroller forum