MSP430FR6043: Not able flash the MCU using MSP FET

Hi Sarwath,

Have you try to use another MSP-FET to connnect this MCU?

Regards,

Zoey

Hi Zoey,

I tried that but I am notable to flash the firmware to the MCU.

how to reset the MSP430FR6043 if it is in brick state.

Now the same issue reproduced in the MSP430FR6043 EVM. In EVM, the LED1 is blinking continuously when I flash the firmware and flashing is not happening.

Regards,

Sarwath

In MSP430FR6043 EVM, we replaced the MCU and tried to flash the firmware. After changing the MCU, Uniflash able to detect the EVM and firmware successfully flashed. 

Could you help to understand this issue? 

I think your chip is dead. Can you tell me what is going on with this Chip before going into death? 

This is happening while flashing the code. 

I think the basic configuration of chip is erased and then something wrong with flashing, and this configuration no longer have data anymore

How to recovery the chip from this issue. It is happening again and again.

I am using the MSP-FET to flash the firmware. Due to this issue, I am unable to detect my MCU in both UNIFLASH and the CCS IDE.

How to reset/recover  the MCU if the basic configuration erased.

Hi,

Sorry for late reply. As there is some error causing my account can not receive message from E2E.

Once the basic MCU is erased, you can not recover it anymore.

Regards,

Zoey