MSP430FR6043: Regarding the Pulse Generation.

?? ??

Part Number: MSP430FR6043

Tool/software:

I am using the MSP430FR6043 for a water meter application.
We are using a pulse signal with a minimum voltage of 0V. Is it possible to output a pulse signal where the positive maximum value (Vmax) and the negative maximum value (Vmin) are equal? If possible, please also provide instructions on how to set it up.

11 months ago

0 Helic Chi 11 months ago

TI__Mastermind 20677 points

Hi, ?? ??

Do you mean you want to output a DC signal? Since that you want positive maximum value (Vmax) and the negative maximum value (Vmin) are equal.

You need this voltage value Vmax = Vmin = ?

Regards,

Helic

0 ?? ?? 11 months ago in reply to Helic Chi

Prodigy 220 points

Dear Helic

Thank you for your reply.

I want to output a rectangular wave pulse signal.Currently, I am outputting a rectangular wave pulse signal with Vmax = ?[V] and Vmin = 0[V]. I would like to output a rectangular wave pulse signal with Vmax = ?[V] and Vmin = -?[V].

Regards

+1 Helic Chi 11 months ago in reply to ?? ??

TI__Mastermind 20677 points

Hi, ?? ??

Do you mean that you want to output a such as +1V, -1V rectangular wave pulse signal?

FR6043 can not output this kind of waveform, this is a hardware limitation.

Only 0V ~ +?V is supported.

Regards,

Helic

0 ?? ?? 11 months ago in reply to Helic Chi

Prodigy 220 points

Dear Helic

Thank you for your reply.

Yes,I want to output a such as +1V,-1V, such as +2V,-2V, and so on.

I understand your answer.

Regards.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430FR6043: Regarding the Pulse Generation.