MSP430F67641: msp430f67641 Pin muxin and configurator

Massimo Romano

Part Number: MSP430F67641
Other Parts Discussed in Thread: SYSCONFIG

Tool/software:

Hello

I'm starting my first project with msp430f67641
I was unable to find the correct tool for pin configuration

For example I would like to test some GPIO and the SD24_B and a UART
Is there any tool for creating .C/.H files for using GPIO and ADC without reading all MCU's registries and setting them manually for this MCU?

Thank you

6 months ago

0 Massimo Romano 6 months ago

Prodigy 40 points

Ok, update

You have to manually add a file .syscfg into the project. Option is not available when you try to add it from menù "File->New->..."

Then the CCS ask you if you wanna set up the SysCongif tool for your project

Now I'm stuck there, the CCS is stuck on "Setting up SysConfig..."

0 Diego Abad Sajamin 6 months ago

TI__Genius 15182 points

Hi Massimo,
As far as I'm aware, SYSCONFIG doesn't support the MSP430. I don't think we have any tool that generates .c/.h files for MSP430. The best option for it will be to look out examples from our SDK, and use that as a reference.

Best Regards,

Diego Abad

0 Massimo Romano 6 months ago in reply to Diego Abad Sajamin

Prodigy 40 points

Thanks, so even the old PinMux seems not supporting it (also it has a dead link for download)

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430F67641: msp430f67641 Pin muxin and configurator