MSP430FR6047: MCU018

Anup Kumar

Tool/software:

Hi,

I am using MSP430FR6047 development board. My observation is :- For fixed set of configurations I am sometimes getting amplitude of UPS signal greater than DNS signal. why this is happening.

Thanks,

Anup Kumar

over 1 year ago

0 Cash Hao11 over 1 year ago

TI__Mastermind 46765 points

Hi,

I not sure why but I would suggest to connect the metal pipe to board GND and use a less number of pulses for test.

Best regards,

Cash Hao

0 Anup Kumar over 1 year ago in reply to Cash Hao11

Prodigy 250 points

Thanks for your reply,

As flow tube doesn't have any wire for ground or any connection. So what do you mean by connecting flow tube to board ground? Do you want to solder a wire on flow tube and connect it to board ground?

Thanks,

Anup Kumar.

0 Cash Hao11 over 1 year ago in reply to Anup Kumar

TI__Mastermind 46765 points

Hi,

Yes, try to solder a wire on the flow tube and connect it to board ground. It could help block the noise from pipe.

Best regards,

Cash Hao

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430FR6047: MCU018