• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 79 subscribers
  • Views 119 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

MSP430F6779:How to perform UART communication using MSP430PEU128?

Donghyun Shin
Prodigy 10 points
Part Number: MSP430F6779
Other Parts Discussed in Thread: MSP-FET, MSP-TS430PEU128

Tool/software:

Hello,

I've set up my development environment by connecting an MSP430F6779 MCU to an MSP-TS430PEU128 target socket board, and then linking it to an MSP-FET debugger.

I'm currently developing in IAR Embedded Workbench and aiming for a baud rate of 9600. However, I'm unable to use printf("hello") over UART.

Could you please advise if there are any additional settings required, or if I might be overlooking a crucial configuration?

Any help would be greatly appreciated!

**Attention** This is a public forum