EVM430-FR6047: To program the evaluation kit

Alan Puthussery Salvi

Hello,

I am using Evm 430 FR 6047 evaluation board with USS GUI .I would like to know more about IDE for programming the evaluation kit and like to have how to start with programming board with sensors by any communication UART or I2C.Is there any document regarding the programing IDE of the board or any other documents regarding the sofwares needed to program the board.

Thanking you

7 months ago

0 Pengfei Xie 7 months ago

TI__Genius 12845 points

Hi Alan,

You could refer MSP430 MCUs Development Guide Book (Rev. A) guidance for the MSP430 programming tool and GUI software details.

It includes a complete introduction on MSP430 ecosystem and hardware/software tools link. Hope it will be helpful.

0 Alan Puthussery Salvi 7 months ago

Prodigy 90 points

Hi Pengfei, EVM 430 FR6047 Board is not getting detected by CCS

0 Alan Puthussery Salvi 7 months ago in reply to Alan Puthussery Salvi

Prodigy 90 points

0 Alan Puthussery Salvi 7 months ago in reply to Pengfei Xie

Prodigy 90 points

HI pengfei,Now my board is detecting.....could please send configuration c code for USS GUI,uss_userConfig.h and uss_userConfig.c for programming and debugging

0 Pengfei Xie 7 months ago in reply to Alan Puthussery Salvi

TI__Genius 12845 points

Hi Alan,

Sorry for late reply. Are you looking for USS library driver and example right?

For the USS water and gas library, they could be downloaded in USS-SWLIB-WATER Driver or library | TI.com and USS-SWLIB-GAS Driver or library | TI.com, and the example is also provided in the library.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

EVM430-FR6047: To program the evaluation kit