MSP430F6779: Debugging the meter using CCS

I got the MSP430F5526LP launch pad it have the on board debugger, can i use this in place of MSP-FET?

Hi Manish,

Yes, you can try to use that.

Best Regards,
Peter

Can i use it without MSP-ISO (Isolator, B/w EVM and Host) ? 

If have Isolator, would be better, but I think you also don't need that just like what LP do because there is no Isolator on the MSP430F5526LP.

while connecting the EVM externally powered with 230V, then can i directly connect the debug probe to PC without isolation?

I believe your 230V high-voltage power supply domain and the MCU's 3.3V power supply domain are actually isolated, right? If there is a good isolation between the high and low voltage region, then don't need to add it, but still need to emphasize that add a isolator would be a safer approach to protect your PC

If the ISO is connected then i can't connect it in the debug mode through JTAG? what is the best approach and how to connect to the JTAG without ISO
and where can i see the calibration values in CCS 
can we connect CCS and the EMDC at the same time?

Hi Manish,

I believe the following documents will help you better understand the connection. Energy Measurement Technology Guide 1.40.00.03

Best Regards,

Peter