MSPM0-CALC: Blackhawk XDS200 schematic needed

Franz Schmid

Part Number: MSPM0-CALC
Other Parts Discussed in Thread: MSPM0L1227-Q1, LP-MSPM0L2228, LP-MSPM0G3507

Team, we are currently connecting the Blackhawk XDS200 through a 20PIN JTAG to MSPM0L1227-Q1 SWD and it doesn't connect. In order to verify the physical JTAG connection the schematic and PIN out of the 20 PIN to 10 PIN (SWD) is needed. Please help to provide this asap.

Kind regards,

Franz

3 months ago

0 Pengfei Xie 3 months ago

TI__Genius 13015 points

Hi Franz,

The recommended debugger for MSPM0 series devices is XDS110 (TMDSEMU110-U Debug probe | TI.com).

If you do not have this debugger currently, any of MSPM0 launchpad has an embedded XDS110 on board. (LP-MSPM0G3507, LP-MSPM0L2228..), and the necessary pin for debugging is SWDIO, SWCLK, GND and VCC.

Best Regards,

Pengfei

0 Franz Schmid 3 months ago in reply to Pengfei Xie

TI__Intellectual 1865 points

hi Pengfei, the XDS110 is(was) out of stock so that my customer purchased the XDS200 debugger which needs to be adopted. Please provide me the schematic or any SW patch to get the XDS200 working. Feedback: 7 days for such an answer is poor!

0 Pengfei Xie 3 months ago in reply to Franz Schmid

TI__Genius 13015 points

Hi Franz,

For the guidance of XDS200 and also the driver needed, please check: XDS200 Debug Probe

For the pin definition for XDS series (including XDS200), please check: XDS Target Connection Guide

But from the support device of XDS200, I do not see MSPM0. I did not use XDS200 before, so I'm not sure whether it could be applied for MSPM0 debugging.

If you/customer have trouble on applying XDS110, you could apply any of MSPM0 launchpad and they has XDS110 embedded on board. It could be connected to customer board for debugging.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSPM0-CALC: Blackhawk XDS200 schematic needed