• Locked Locked
  • Replies 3 replies
  • Subscribers 78 subscribers
  • Views 269 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Re: Code composer v5.1.1 problems to run

Raul Perez97830
Prodigy 60 points

Hi Lisa,

I ran the program. Now I figth to change the port that I have connected the MSP430G2. How I change the port? Could you help me, please?   

Thank you,

Raul

P.D.: The problem with the installation was that I tried to install for all the devices, and finally I only installed to MSP430

  • TI__Guru*** 130875 points

    Hi Raul,

    glad to hear you got things installed. 

    Can you please post your MSP question to the MSP forum?  I will split the thread for you. 

    All the best with development.

    Best Regards,

    Lisa

  • Guru 27285 points

    Raul Perez97830 said:

    Hi Lisa,

    I ran the program. Now I figth to change the port that I have connected the MSP430G2. How I change the port? Could you help me, please?   

     Hi Raul, please explain better your problem, may be some part remained on original post. Which port?

     Regards

     Roberto

  • Expert 1610 points

    Hi Raul,

    when you have successfully installed CCSv5 it should have installed drivers for the FETs (Flash Emulation Tool -  the "programmer" for MSPs) too. If you connect a FET (for example a lauchpad) it should be detected by windows when plugging in. Which FET do you use?

    Maybe right-click on your project, select properties and in the general tab you can pick a connection - if that's solves you problem. If not, please repost your question or give some more information about your problem.

**Attention** This is a public forum