• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 79 subscribers
  • Views 436 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

MSP-GANG430 problem

Remony
Expert 1560 points
Other Parts Discussed in Thread: MSP430F5308

Hi,

I find a problem when using MSP-GANG430 to program MSP430F5308.

programming using MSP-FET430UIF is ok. And othre devices is ok.

But programming MSP430F5308 has problem.

Below is screen capture about error and version of GANG programmer.

 

Would you have any suggestion on this?

Thanks.

  • 0
    TI__Mastermind 22165 points

    Remony said:
    Would you have any suggestion on this?

    Can you provide me with the below information?

    1) How is the F5308 powered during programming? Is it powered by the GANG430 Tool, or is it powered by a local power supply on the Board?

    2) At which voltage do you program the F5308 device?

    3) Are you using the 4-wire or the 2-wire (Spy Bi Wire) JTAG?

    4) Is it possible for you to send us the schematic of your design?

    5) Are you using the original JTAG cable that was provided by TI or a special JTAG cable, i.e. a Adaptor cable? If yes, what is the lenght of the Adaptor cable?

    BR,

    Mo.

**Attention** This is a public forum