how to read ADC memory for auto scan mode without using DMA

PARTHIBAN V

i am new to use MSP430F5152 .. actually i having problem in using ADC . how to set ADC10CTL1 Register for auto scan mode and how to read ADC memory for auto scan mode without using DMA pls can any one solve this issue..

if possible pls send me a sample code for doing this...

thanks in advance

over 12 years ago

0 Ilmars over 12 years ago

Guru 46710 points

Did you try reading user manual? Which part you did not understand?

0 PARTHIBAN V over 12 years ago in reply to Ilmars

Prodigy 190 points

how to read ADC value for auto scan mode without using DMA

0 Ilmars over 12 years ago in reply to PARTHIBAN V

Guru 46710 points

Please refer to SLAU208L, chapter: "27.2.7.4 Repeat-Sequence-of-Channels Mode (Repeated Autoscan Mode)".

PARTHIBAN V said:
how to set ADC10CTL1 Register for auto scan mode

ADC10CONSEQx = 11

PARTHIBAN V said:
how to read ADC value for auto scan mode without using DMA

By reading contents of ADC10MEM0 after each conversion.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

how to read ADC memory for auto scan mode without using DMA