Can I use MSP-FET UIF to program for FR2xx

redflood

Intellectual 780 points

Hi everyone,

Plz help to answer my question as above.

I used this tool 'Lite FET-Pro430 Elprotronic', but I can not see FR2xx in target mcu options.

Thanks in advanced!

over 10 years ago

0 Dennis Eichmann over 10 years ago

Guru 74080 points

But this is then related to the Elpotronic software, not the FET. The FET will do it if he got updated to a firmware version which contains the device you want to use. CCS, for example, updates the FET when it recognizes an older version. But the Elpotronic software can do this, too. You should look for a newer version of FET-Pro430.

Dennis

0 redflood over 10 years ago in reply to Dennis Eichmann

Intellectual 780 points

But, is it possible?

0 Dennis Eichmann over 10 years ago in reply to redflood

Guru 74080 points

I'm not aware of any reason that might prevent you from doing that. I used the FR6989 with the grey FET, too.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

Can I use MSP-FET UIF to program for FR2xx