Problem connect with MSP430G2955 and ez430chronos SBW programmer

Thomas M

Other Parts Discussed in Thread: MSP430G2955, MSP-FET

Hello

I have problem. I have MSP430G2955 and SBW programmer with ex430 chronos. And i can't programming G2955 this sbw programmer. In CCS5 always i have message - Error connecting to the target: Could not find device (or device not supported).

what is problem

best regards Thomas

over 10 years ago

0 Ryan Brown1 over 10 years ago

TI__Guru**** 223367 points

Hello Thomas,

The eZ430 hardware only supports MSP430F20xx/F21x2/F22xx/G2x01/G2x11/G2x21/G2x31 devices. You will need to use a MSP-FET430UIF, MSP-FET or eZ-FET (like those found on MSP430 LaunchPads other than the MSP-EXP430G2) to program your MSP430G2955 device using SBW.

Regards,
Ryan

0 zrno soli over 10 years ago

Guru 34973 points

Thomas M said:

I have problem. I have MSP430G2955 and SBW programmer with ex430 chronos. And i can't programming G2955 this sbw programmer. In CCS5 always i have message - Error connecting to the target: Could not find device (or device not supported).

If I remember right, it is possible by using mspdebug.

forum.43oh.com/.../3622-programming-a-msp430g2955

0 Thomas M over 10 years ago in reply to zrno soli

Prodigy 40 points

Thank You. I buy MSP-FET and all processors is programming :)

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

Problem connect with MSP430G2955 and ez430chronos SBW programmer