MSP430G2553 In-Circuit programming

Allen Keefe44

Other Parts Discussed in Thread: MSP430G2553

I am in need of some kind of a "Programmer to Go" that can be integrated into a Keysight In-Circuit test fixture. The target device is MSP430G2553IPW28 and would be mounted on the board for test. The designer has designed the board to use both the J-Tag pins and the SWD pins, so either interface would be considered for use. Any assistance would be greatly appreciated.

Regards,

Allen Keefe

over 9 years ago

0 zrno soli over 9 years ago

Guru 34773 points

You need debugger or just flasher? Let say that connection between programmer and MSP430G2553 is SBW. Is there need for any signals between programer and Keysight testing device? "programmer to go" should work as standalone device without PC, or not?

0 Allen Keefe44 over 9 years ago in reply to zrno soli

Prodigy 20 points

The only signals that I am aware of needing would be the "START" and "BUSY" if using a flasher as a "programmer to go", just need to know which "flasher" would be needed.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430G2553 In-Circuit programming