Hi,
I am in the process of designing a PCB based on the MSP430G2211. I am fairly new to PCB design, and to working with TI MCUs in general. My plan is to program the chip via SBW directly with this FTDI JTAG dongle:
http://www.ftdichip.com/Support/Documents/DataSheets/Cables/DS_C232HM_MPSSE_CABLE.PDF
Before I implement my design, I want to make sure that I'm not missing something about how these MCUs are programmed.
Can I program directly with this dongle by connecting to the SBWTDIO (with 47k pullup resistor) and SBWTCK pins on the MCU?
Any advice would be much appreciated.
