MSP430F447: I2C interface design

senthil kumar66153

Part Number: MSP430F447

I am planning to interface I2C eeprom to microcontroller msp430f447 .I want to know how to design schematics.Because i don find SDA,SCL pins in the pindetails but the datasheet shows u can interface I2c devices to this processor.

with regards

senthil

over 8 years ago

0 Dietmar Walther over 8 years ago

TI__Genius 14165 points

Hi Senthil,

thanks for asking it looks like the product page shows a failure here. The point is that the F447 device has the USART module implemented and not the USCI module. Therefore it supports UART and SPI mode but no I2C.

The F4794 for example has the USCI module and supports I2C.

I already contacted the corresponding person in TI to correct this. Sorry for the confusion.

0 senthil kumar66153 over 8 years ago in reply to Dietmar Walther

Intellectual 390 points

hi thanks for the reply

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430F447: I2C interface design