• State Resolved
  • Locked Locked
  • Replies 5 replies
  • Subscribers 80 subscribers
  • Views 1259 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

MSP430F5132: MSP430F5132

Hemantha Kumara
Intellectual 350 points
Part Number: MSP430F5132
Other Parts Discussed in Thread: PMP, BQ24650

Dear Sir,

We are developing our design of Solar inverter and for that we are using PMP7647 as a lded driver . So we need  gerber details and source code for this driver circuit to develop our PCB.

Please advice where we can get the gerber details and source code for this driver circuit.

Thanks and regards,

Heamantha Kumara N K

  • 0 in reply to Wei.Jetim Zhao
    Intellectual 350 points
    THANK YOU SO MUCH JETIM
  • 0 in reply to Wei.Jetim Zhao
    Intellectual 350 points
    Dear Sir,

    In the above which you were shared ,gives me the gerber file details . Thanks for the update.
    And for my design i need source code to dump ,so please advise me where can i get ?

    Thanks and regards,
    Hemantha Kumara N K
  • 0 in reply to Hemantha Kumara
    Intellectual 350 points
    We have selected bq24650 and PMP 7647 from TI the requirements. We have few quires on this.
    1. Can we interface bq24650 with Lead Acid, Tubular Positive Plate Flooded or Tubular GEL / AGM, VRLA, 12V- 40AH @ C/10 discharge rate batteries?
    2. We would like to have scalable input power from 7.2W to 45W. Please help us to achieve this.
    3. Can we achieve 3 stages of charging? Bulk, Absorption and Float methods.
    4. Charging voltage shall be programmable.
    5. We would like to have RTC interface to control the brightness of the led lamp with different time zones and should be programmable.
    6. can you please share the reference design, source code of these two part?

    Thanks & Regards,
    Hemantha Kumara N K
  • 0 in reply to Wei.Jetim Zhao
    Intellectual 350 points
    We have selected bq24650 and PMP 7647 from TI the requirements. We have few quires on this.
    1. Can we interface bq24650 with Lead Acid, Tubular Positive Plate Flooded or Tubular GEL / AGM, VRLA, 12V- 40AH @ C/10 discharge rate batteries?
    2. We would like to have scalable input power from 7.2W to 45W. Please help us to achieve this.
    3. Can we achieve 3 stages of charging? Bulk, Absorption and Float methods.
    4. Charging voltage shall be programmable.
    5. We would like to have RTC interface to control the brightness of the led lamp with different time zones and should be programmable.
    6. can you please share the reference design, source code of these two part?


    Regards,
    Hemantha Kumara N K

**Attention** This is a public forum