• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 79 subscribers
  • Views 782 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

MSP430F6736A: CPU reset

Majin Boo
Prodigy 90 points

Part Number: MSP430F6736A
Other Parts Discussed in Thread: MSP430F6736

I have designed PCB for energy measurement. I used CPU MSP430f6736a and program's TI Support. When I run program for a while (about 1 day) energy reset.It start to count from zero.

But I tried to use CPU MSP430f6736 (non a) .It didn't reset. Whyyyy??? Problem is software or hardware or cpu. Who ever face this problem. Could you please reply me.

I want to know what is the 'cause of this problem. and I want to know solution the problem.

Thank you.

  • 0
    TI__Genius 10980 points
    Hi,

    I would need more information about your application to figure out what might be causing this, such as if you saw this discrepancy consistently, and what modules you were configuring/using. However, please see the following app note on the differences between the A and non-A devices: www.ti.com/lit/an/slaa666/slaa666.pdf

    Hopefully this will allow you to see what differences are causing your issue.

    Regards,
    Nathan
  • 0 in reply to Nathan Siegel
    Prodigy 90 points
    Hi, Nathan

    I used the same software(from ti support) and hardware(my designed) but different CPU. Measure as the same load and the same time.
    A reset but non-A doesn't. I tested until sure.
    what can be the 'cause of CPU reset ?
    where I should go to check it ?
  • 0 in reply to Majin Boo
    TI__Genius 10980 points
    Hi,

    Depending on exactly what software examples you are using, there may be differences between the A and non-A devices. Please use the software provided with the correct product page. You issue may gave to do with using incorrect header files or other IDE project settings that would need to be changed when migrating from one device to the other.

    Regards,
    Nathan

**Attention** This is a public forum