TIDM-SUB1GHZ-MESH-NETWORK: NC Drill file missing

Vikram Rastogi

Prodigy 40 points

Part Number: TIDM-SUB1GHZ-MESH-NETWORK
Other Parts Discussed in Thread: CC1101, MSP430G2533

Hi,
I am trying to explore http://www.ti.com/tool/TIDM-SUB1GHZ-MESH-NETWORK

over 8 years ago

0 Fredrik K over 8 years ago

TI__Guru** 106705 points

Hi Mohan,
I have notified the author of the TI Design about your question.

Cheers,
Fredrik

0 Fan_Zhang over 8 years ago

TI__Expert 4590 points

hi, Roy,

would you please describe in more detail about your problem.

BTW, the project should be run with IAR.

0 Vikram Rastogi over 8 years ago in reply to Fan_Zhang

Prodigy 40 points

Hi!
I was viewing the gerber files that are provided for the PCB board. They don't seem to have the NC drill files for the PCB! Can those be provided?
Regards

0 Fan_Zhang over 8 years ago in reply to Vikram Rastogi

TI__Expert 4590 points

hi, you can generate it from CC1101_MSP430G2533.PcbDoc file

0 Vikram Rastogi over 8 years ago in reply to Fan_Zhang

Prodigy 40 points

Hi! Is it possible to get the full project folder for this? I want to do small modifications in the design which are not possible without the files that are not present.

0 Fan_Zhang over 8 years ago in reply to Vikram Rastogi

TI__Expert 4590 points

Currently, code for this TI Design is only available in .lib form.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

TIDM-SUB1GHZ-MESH-NETWORK: NC Drill file missing