CCS/MSP-EXP430G2: Internal and External ADC channel access simultaneously

i am using Repeat sequence of channels.
Internal channel also changes as i vary external channel.

Here is the Code below

#include <msp430g2553.h>
long temp;
float IntDegC0=0.0,IntDegC1=0.0;
#define mem1 (*(unsigned int*)0x244)
#define mem0 (*(unsigned int*)0x246)

int main(void)
{
WDTCTL = WDTPW + WDTHOLD;
ADC10CTL1 |= INCH_1 + CONSEQ_3;
ADC10CTL0 = SREF_1 + ADC10SHT_2 + REFON + ADC10ON + MSC;

ADC10DTC1=2;
ADC10AE0=BIT0;
__delay_cycles(1000);

while(1)
{
ADC10CTL0 &= ~ENC;
while (ADC10CTL1 & BUSY); // Wait if ADC10 core is active
ADC10SA = 0x244; // Data buffer start
ADC10CTL0 |= ENC + ADC10SC; // Sampling and conversion start

IntDegC0 = ((float)1.5*mem0*100)/1024; // External LM35 connected // for testing i have connected potentiometer
IntDegC1=((float)mem1/1024)*3.3; // Internal Temparature sensor
__no_operation(); // SET BREAKPOINT HERE
}
}

Even if i use INCH_10(Sample all from A0 to Temp), i am not getting the output. It just shows one of the output properly.

could you please try the sample code adc_temp.c to check if the temp sensor is working properly?

best regards

Lukas

Let me check your code on bench.

I will come back to you next week.

Best regards

Lukas

DIP package