CCS/MSP432P401R: -

user5148774

Part Number: MSP432P401R
Other Parts Discussed in Thread: MSP-FET

Tool/software: Code Composer Studio

I'am looking for a example showing how to debug MSP-EXP432P401R Rev 2.1 using MSP-FET Rev 2.0.6- and MSP-FET-432ADPTR Rev 1.0 CCS 8.2.0.00007, but I can't find it.

It would help me a lot.

over 6 years ago

0 Chris Sterzik over 6 years ago

TI__Guru 65341 points

I do not believe that an example exists. The MSP-EXP432P401R has the XDS110 built into the launchpad, so the fet is not needed. You can still use the FET and the FET adapter, you would need to remove all of the jumpers and then connect the 10-pin ARM connector to J8. Power can either be supplied or sensed through the fet adapter. If sensed you could use the 3.3V from the XDS110 or another source.

Regards,
Chris

0 user5148774 over 6 years ago

Prodigy 230 points

What should I Select ?

I would like to use MSP FET

Or have I missed some installation ?

If so how do I do ?

0 Chris Sterzik over 6 years ago in reply to user5148774

TI__Guru 65341 points

It will be the TI MSP430 USB1.

Regards,

Chris

0 user5148774 over 6 years ago in reply to Chris Sterzik

Prodigy 230 points

Unable to verify or finish

What should I do ?

0 Chris Sterzik over 6 years ago in reply to user5148774

TI__Guru 65341 points

Use the recommend SDK Examples and navigate to a project.

You can also import a project: Project->Import CCS Project and go to here ;

C:\ti\simplelink_msp432p4_sdk_2_30_00_14\examples\nortos\MSP_EXP432P401R\driverlib\gpio_toggle_output\ccs

Please refer to the getting started guide:
dev.ti.com/.../

Regards,
Chris

0 user5148774 over 6 years ago in reply to Chris Sterzik

Prodigy 230 points

Backgrund and some explanation. I have no problem using MSP-EXP432P401R with its internal debugger. The problem is I would like to use MSP FET to test it before I test it on my board. I will use 2.5V as VDD on my board and that leads me not to use the debugger on MSP-EXP432P401R.

0 Chris Sterzik over 6 years ago in reply to user5148774

TI__Guru 65341 points

Were you able to open the resource explorer and use one of the example projects?

Thanks,
Chris

0 user5148774 over 6 years ago in reply to Chris Sterzik

Prodigy 230 points

Resetting with S3 on MSP-EXP432P401R and continued without verified connection. A question of firmware update was asked. After this it worked.

Thank You

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

CCS/MSP432P401R: -