MSP-EXP430F5529LP: USB2ANY Firmware for Evaluating LMH1297

Austin Keener

Part Number: MSP-EXP430F5529LP
Other Parts Discussed in Thread: USB2ANY, LMH1297

Hello,

Is the USB2ANY firmware available to be flashed onto the MSP-EXP430F5529LP launchpad? I need to read the SPI registers on an LMH1297 chip on a custom PCB, and the SigCon Architect tool is designed to work with the USB2ANY firmware.

Thanks,

Austin Keener

over 5 years ago

0 Eddie LaCost over 5 years ago

TI__Mastermind 43580 points

Hello Austin,

I have not seen firmware that was meant for the launchpad board, but the USB2ANY does use the MSP430FR5529. You could check the schematics and see if the launchpad configuration could work. This is also what was suggested in the thread below.

https://e2e.ti.com/support/tools/sim-hw-system-design/f/234/t/789774?USB2ANY-bootloader-firmware

0 Austin Keener over 5 years ago in reply to Eddie LaCost

Prodigy 50 points

Upon further investigation, it looks like SigCon Architect tool does not support the SPI interface to the line drivers. I ended up writing a custom SPI driver to connect to the chips.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP-EXP430F5529LP: USB2ANY Firmware for Evaluating LMH1297