MSP430F6436: Calculating checksum on TI tools

U-SK

Genius 5840 points

Part Number: MSP430F6436
Other Parts Discussed in Thread: UNIFLASH, CONTROLSUITE

Hello,

Are there any way to calculate checksum value on CCS or Uniflash or other TI tools?

Regards,

U-SK

over 6 years ago

0 Dietmar Walther over 6 years ago

TI__Genius 14165 points

Hi,

hope the link below helps

From the Experts: Perform cyclic redundancy checking using linker-generated CRC tables

Other Parts Discussed in Post: CONTROLSUITE To verify code and/or data integrity, TI’s microcontroller (MCU) Code-Generation Tools (CGTs), including the C2000™ MCU CGT, the MSP430™ MCU CGT and the TI ARM…

By Todd Snider over 9 years ago in Archives > Tools Insider

0 Dietmar Walther over 6 years ago in reply to Dietmar Walther

TI__Genius 14165 points

The Uniflash tool which is a stand-alone flash programmer can compute the CRC of the entire flash region when the part is programmed but not sure if that is what you are looking for.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430F6436: Calculating checksum on TI tools