CCS: MSP430FR2111 config the waveform issue

bert xu

Prodigy 110 points

Other Parts Discussed in Thread: MSP430FR2111, MSP430WARE

Tool/software: Code Composer Studio

Hi：

We use the MSP430FR2111 to control the motor ，need to configure the waveform as follows（ waveform.jpg）：

Could you help Help us configure this waveform and provide code？Thanks！

over 5 years ago

0 Srinivas Lingam over 5 years ago

TI__Expert 7365 points

Hi Bert,

You can look at the code example timer_b_ex1_continuousModeCCR0 in the MSP430Ware. The Timer can be used to set the period for your H or L on each of the GPIOs. It configures P1.0 initially to output pin and toggles every Timer period. You can add the same functionality for the GPIOs P2.1, P2.0, P1.5 & P1.4 above.

Srinivas

0 bert xu over 5 years ago in reply to Srinivas Lingam

Prodigy 110 points

Hi，Srinivas：

Thanks for you reply this issue.I will try it and feedback the result。

Thanks！

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

CCS: MSP430FR2111 config the waveform issue