CCS/MSP430F6779A: how to read data from EMDC code generator code

EST

Part Number: MSP430F6779A
Other Parts Discussed in Thread: MSP430F6779, MSP430FR2475

Tool/software: Code Composer Studio

Dear Sir,

I have my own board design using MSP430F6779 with MSP430FR2475 IC's.

Code is generated (MSP430-F6779_CT_3V_3C_50Hz) from EMDC (CCS compiler). how to read the data from MSP430F6779 through UART?

If need any commands transmitted to MSP430F6779 from MSP430FR2475?. Please send soon. Thank you

My UART hardware interface below,

MSP430F6779 -- MSP430FR2475

TXD (P3.1) ----- RXD

RXD (P3.0) ------ TXD

over 5 years ago

0 James Evans over 5 years ago

TI__Mastermind 49692 points

Hello Siva,

Thanks for your post and for using EMDC. If the MSP430FR2475 is used as the host in your system, then you'll need to use the same commands that the EMDC GUI uses as the host. You can find those commands including the packet structure in the Communication Protocol Spec section in the EMDC Technology Guide.

Regards,

James

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

CCS/MSP430F6779A: how to read data from EMDC code generator code