• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 30 subscribers
  • Views 400 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

DRV8800: Resistor sizing

DRV8800: Pull down resistors values ?

Nir Flysher
Expert 3367 points
Part Number: DRV8800

Dear Team,

Can you please advise how to set the values of the pull down resistors on pins Mode,Phase,Enable,nSleep ?

Regards,

Nir.

  • 0
    TI__Guru 56650 points

    Hello, Nir,

    According to spec table and test condition comments, nSLEEP pin has 100kohm pulldown resistor. Enable pin has 50kohm pulldown resistor. Mode pin's pulldown resistor is less than 100kohm.

    Regards,

    Wang Li