• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 29 subscribers
  • Views 281 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

MCT8316A: Write EEPROM issue

Daisuke Higa
Genius 4315 points
Part Number: MCT8316A

Tool/software:

Hi Joshua-san

Please provide the remaining answers for the post below.

https://e2e.ti.com/support/motor-drivers-group/motor-drivers/f/motor-drivers-forum/1371872/mct8316a-write-eeprom-issue

I forgot that there is one thing I haven't heard from you about.

Is there any update on the following matter?

Daisuke Higa said:
Could you tell me any other settings that require a power cycle?
            You said:

            I will ask our firmware team for some examples of the settings which set only when the device is powered on. I will aim to provide an update tomorrow.

Best regards,

Higa

  • 0
    TI__Mastermind 23950 points

    Hi Higa-san,

    Apologize on the delay in response, I have not gotten a response from our firmware team yet for specific examples of peripheral settings are set at power up.

    I have reached out to the firmware team again to try and get an answer. 

    When I get a response from our firmware team, I will provide the response in the thread you linked. In the meantime, I will close this thread.

    Regards,

    Joshua