What do I hook the Pack- pin and Bat - pin to? I have a multicell stack up and only have two inputs (Bat+ and Bat-).
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
What do I hook the Pack- pin and Bat - pin to? I have a multicell stack up and only have two inputs (Bat+ and Bat-).
Hello Nick,
The two nodes are only separated by the gauge sense resistor. BAT- should be connected directly to the terminal. PACK- and PACK+ are used in your final system. You can reference the EVM schematic.
Sincerely,
Wyatt Keller
So the Bat- comes in and goes through the sense resistor and that's how it connects to GND?
this also shows Bat- connected directly to GND (unless thats just shield) which is the part that makes it a little more confusing.
I am guessing that Bat- comes in and goes through the sense resistor and becomes the board GND or load GND, so Pack- = board GND???
Hi Nick,
The diagram in Section 2.2 EVM Connections of the EVM User's Guide explains the connections a little more clearly. You directly connect your battery cells to Bat- and Bat+. The charger and system load should be connected across BAT+ and PACK–.
Best,
Jessica