UCC28C56H: driving a PWM signal into RT/CT pin

Henry Vo

Part Number: UCC28C56H

Hello,

is it possible to drive a PWM signal into the RT/CT pin rather than installing R & C? if not possible, can you recommend a part that allows this function?

thank you.

9 months ago

0 Steven Mappus1 9 months ago

TI__Mastermind 24905 points

Henry,

Please refer to page 21 of the UCC28C56 data sheet:

Also, refer to previous, related E2E post listed below:

https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/188696/synchronization-of-ucc28xx-series-pwm

Regards,

Steve

Power management

Power management forum

UCC28C56H: driving a PWM signal into RT/CT pin