TPS6594EVM: Where I can download the source code or binary that flash into MSP432E401Y chip?

Updates:

After flash the `acctrl.0.3.0.3b.bin`, still the PMIC GUI cannot found any ports avaiable.

Try following these steps:

1. Download the BSL Scripter and install it in C:\ti\ on the PC. (click here)
2. Copy provided script (scriptDFU.txt) and source file (aevm_1_0_3_6.txt) into C:\ti\BSL-Scripter.
3. Connect the EVM to PC with the USB cable
4. In C:\ti\BSL-Scripter, open BSL-Scripter.exe.
5. In the new command window, type “scriptChrisDFU.TXT” to flash the MCU.
6. Disconnect the USB cable to remove the EVM power.
7. Restart the EVM, by plugging in the USB cable.
8. Verify that EVM is working with GUI

6825.aevm_1_0_3_6.txt

scriptDFU.TXT

Hello Michael,

Thanks for your reply.

I tried both the xds110 usb and the one near the RJ45, neither of them works.

Hello Louis,

I am sorry, but if that method doesn't work, I recommend using a TPS6594EVM ('1212 or '1111, it doesn't matter) and connecting the I2C lines from the EVM to your board that has a TPS6594. 

Hello Michael,

The txt is downloaded to the flash via uniflash tool.

I cannot found the driver, can you attach the driver here? Thanks.

I do not have the driver. If the method I provided earlier doesn't work, please use one of the PMIC EVMs to connect to your board. 

Regards,

Mike

Hello, other members are able to connect the PMIC with MSP432E401Y  EVM.

https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1122293/tps6594-how-to-connect-msp432e401y-and-scalable-pmics-gui-on-pc

What is the prerequisite to use your method? Any bootloader need to download first?

Hello Louis,

For the post you referenced, there wasn't an issue communicating with the board. The board was recognized by the PC in the COM ports and GUI recognized the MSP432 EVM. 

That customer had received a board from us loaded with the necessary software/firmware to work with the GUI. We no longer support this method. Please utilize the TPS6594EVM. 

Hello,

I learned it from the Scalable PMIC's GUI User’s Guide, and now you told me that it is not supported.

www.ti.com/.../slvubt8b.pdf

Hi Louis,

I am not sure why you were not successfully able to load the firmware for the MSP432. If the steps you have tried did not work, I highly suggest you obtain the TPS6594EVM - this EVM has the MSP432 integrated on the board which is already pre-loaded with the correct firmware, so all you need is to plug in the USB cable and you will have communication with the GUI.

Unfortunately, we do not have any other way to help you debug your MSP432 EVM other than what has already been suggested.

Best regards,

Matt