BQ27220EVM-744: Need EDV configuration details

Hello Hitesh, 

I'm not sure if I fully understand your question, please see the comments below: 

• DefaultDesignCapacity: The design capacity of the cell you are using, listed in the cell datasheet. 
• EDV0, EDV1, EDV2: Three low-voltage thresholds of the battery. EDV0 is the voltage when the SOC is at 0%, EDV1 is the voltage when SOC is at 3%, and EDV2 is the voltage when the SOC is at 7%. 
• Gauging Configuration: Please refer to the image below: 

• EDV0_HOLD_TIME, EDV1_HOLD_TIME, EDV2_HOLD_TIME: These values are the hold times for EDV0, EDV1, and EDV2, and can be left as the default values. 
• CC_OFFSET: This command instructs the fuel gauge to measure the internal CC offset value.
• BOARD_OFFSET: This command instructs the fuel gauge to measure and store the board offset value.
• CC_GAIN: CC Gain sets the mA current scale factor for the coulomb counter. Use calibration routines to set this value
• CC_DELTA: CC Delta sets the mAh capacity scale factor for the coulomb counter. Use calibration routines to set this value

Regards, 

Jonny.