• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 64 subscribers
  • Views 103 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCC5350: Low impedance failure

Brian Wang0928
Genius 13200 points
Part Number: UCC5350

Tool/software:

team,

A short circuit was found recently on the IC pin, and some IC materials might be affected by tidal waves due to a typhoon flooding in Taiwan in July!
The customer found that there were several PCB boards that were shorted when the electricity power was switched on.
Not sure if it is due to moisture or electrical issues, please help to explain and offer advice. 

VCC(Pin 1) to Ground(Pin 4) => Low Impedance

Pin 8 to Pin 5 => 2.5 Ohm

Pin 7 to Pin 8 => 3.5 Ohm

 

Application: ups

Regards

Brian

  • 0
    TI__Expert 6846 points

    Hi Brian,

    First, I would like to know any possible confirmation of external water damage.

    • Were there any hints of damage through moisture/water on these boards?

    With damage on both primary and secondary side, it makes me think that it is damaged by an external factor.

    These impedance measurements definitely show damage to most likely the internal diodes in the driver due to EOS.

    Regards,

    Hiroki