BQ24600EVM: Unable to charging in the Lithium Polymer Battery

Vignesh Babu R

Part Number: BQ24600EVM
Other Parts Discussed in Thread: BQ24600

Tool/software:

Hi,

In HPA421 Evaluation model.Where I connected the Lithium Polymer Battery(14.8V).But the Model not yet to start up the Charging when I connected the Battery with the EVM.What are the things am I check through Hardware.The LEDS Like Status pin are always Blinking and PG inidcates Red color.

8 days ago

0 Christian Moyer 7 days ago

TI__Mastermind 18500 points

Hello Vignesh,

Here is the STAT Pin Definition for BQ24600:

What is the input voltage you are using?

Best Regards,

Christian.

0 Vignesh Babu R 7 days ago in reply to Christian Moyer

Prodigy 70 points

Hi,

My Input Voltage is 20V and its given through DC Power Supply.But the EVM can't change the status according to the STAT Pin Definition for BQ24600.Thank you.

0 Christian Moyer 6 days ago in reply to Vignesh Babu R

TI__Mastermind 18500 points

Hello Vignesh

Please refer to section 7.3.14 Temperature Qualification:

Your device is running into charge suspend, because your battery does not have a thermistor. If you place a 10k resistor in between the TS terminal and GND Therminal, It should resolve the issue.

Best Regards,

Christian.

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Power management

Power management forum

BQ24600EVM: Unable to charging in the Lithium Polymer Battery