TPSM64406EVM: TPSM64406

Hi Mark,

These items (minus the gerber files) are available on the product page. Please send over your email, and I can send the design files there.

Thank you,

Joshua Austria

mark.liebendorfer@idd.safrangroup.us

In the EVM link you provided, I do not see any files (archive or otherwise) that could contain schematic or board layout files.

Joshua,

I'm looking for CAE files that have been generated by CAE software.  One would be an editable schematic file from software like OrCAD or Altium.  The net list from that file would have been used to create an editable board layout file.  Which is the layout file?  What software was used to generate these files?  It is not obvious from the file extensions (".XXXXX"). 

Right now, gerber, drill, or other manufacturing files are useless to me.

Very helpful, thanks.  We're using OrCAD X - I'm hoping I can convert them.

So close! 

OrCAD's translator documentation says the file named "BSR281.SchDoc" must be exported in ASCII format.  The instructions are simple.  May I send them? 

Hi Mark, 

Yes you can, and I will see what we can do.

Thank you,

Joshua Austria

How do I attach the instructions .pdf file?

Hi Mark,

You can either take a screenshot or send over the link.

Thank you,

Joshua Austria

John,

The full doc is at:

e2e.ti.com/.../alt2cap.pdf

If you have Altium, export the .SchDoc file as ASCII.  It is a simple operation shown on page 3 of the linked pdf.

Hi Mark,

Here you go:

 BSR281.SchDoc

Please let me know if this works,

Joshua Austria

It also needs the BSR281_Hardware.SchDoc file to be ASCII.  After that, it should be good to go.  Thanks for your patience.