Starterware/BQ34Z100-G1: BQ34Z100-G1

Philipp Dalkowski

Prodigy 20 points

Part Number: BQ34Z100-G1
Other Parts Discussed in Thread: BQSTUDIO

Tool/software: Starterware

Hello,

every time when I try to calibrate the voltage I get: calibration- a read of data written failed comparison.

The other calibration options work.

I have 10 series cells . Also the capacity does't display it properly.

Thanks.

test1.doc

over 8 years ago

0 ThomasCosby over 8 years ago

TI__Guru 73830 points

The Pack Configuration register is set to 0, so the VOLTSEL bit is not set. This bit needs to be set to select the external resistor divider to measure the battery voltage. You should also download the latest version of bqStudio, if you have not down so. It is v1.3.72 and it is available on the bqStudio website.