EV2300: EV2300 (.gg and .senc file) ic programming using LabVIEW

Jessie Tercero

Prodigy 10 points

Part Number: EV2300

Hi Experts,

Is it possible to load .gg and .senc file without using TI bq Gas Gauge Evaluation Software? and use LabVIEW?

We have new requirement from our customer to automate the bq ic programming process.

Thanks,

Jessie

over 6 years ago

0 David Hien over 6 years ago

TI__Genius 10830 points

Hi Jessie,

I wanted to let you know that your post has been assigned to one of our applications engineers. This week takes place our annual Battery Management Deep Dive event for which all our engineers are all hands on deck. He will be able to your post early next week, once this event is over.

You can check out recordings of much of the material we present at www.ti.com/deepdive

Thank you for your understanding!

0 Swaminathan Ramanathan75031 over 6 years ago in reply to David Hien

TI__Expert 6575 points

Hi Jessie,
We don't have anything specifically for LabView, but please check this e2e post here:
e2e.ti.com/.../705280
The Tools SDK is provided as is (no support), but it has some DLLs that can be imported and used in LabView for programming and communicating to the gauge.
Regards,
Swami

Power management

Power management forum

EV2300: EV2300 (.gg and .senc file) ic programming using LabVIEW