Part Number: AM263P4-Q1 Other Parts Discussed in Thread: UNIFLASH This FAQ explains how to setup the flash utility to flash into external flashes which are not supported out of the box. The method mentioned in this FAQ would be the same for AM261 and…

Part Number: TDA4VH-Q1 How to enable the constant monitoing of the linux and remotecores of main domain from mcu domain core (mcu1_0)? If core is crashed and detetion is done by monitoring, how to enable autonomous recovery?

Part Number: TDP2004 This Master FAQ lists serves as a point of reference to find all FAQs made by TI's signal conditioning Team. DPHY: 1. [FAQ] SN75DPHY440SS: Is it okay to swap the polarity and lane order? - Interface forum - Interface - TI E2E…

Part Number: AM625 This FAQ answers questions about minimum DDR requirement on AM62x, boot-time memory usage, and what changes are needed to boot successfully with reduced DDR. This FAQ is still in progress.

Part Number: MSPM0-SDK This thread is used to update the software or hardware update for application note of Single Phase AC Power Monitor with MSPM0 Hardware_Software.zip

Part Number: C2000WARE Other Parts Discussed in Thread: C2000WARE , SYSCONFIG This post is meant to specify erratas /document any refinements or clarifications discovered after the C2000Ware release. Sysconfig migration/Switch feature in Sysconfig…

Part Number: TDA4VL-Q1 Other Parts Discussed in Thread: TDA4VL , TDA4VH When using the MCU_ADC0 or MCU_ADC1 on TDA4VL or TDA4VH, the voltage measured on ADC0_AIN7 or ADC1_AIN7 has a higher voltage than expected (i.e., for an expected voltage of 0.8V…

Part Number: TDA4VH-Q1 Hi, Could you please guide us on method to inject error on ring accelerators.Thank you.

This serves as a selection guide for our automotive-grade devices and outlines the typical protocols associated with these devices. 1:1 2:1 3:1 4:1 8:1 SN74LVC1G66-Q1 SN74LVC2G66-Q1 TMUX7212…

Part Number: TDA4VEN-Q1 Trying to reset c7x through CCS issues a double page fault.