Part Number: TPS546E25 How to Change TPS546E25 PMB_ADDR (0xD3) on a Secondary Device in a 2-Phase Configuration There are multiple devices on the serial bus and need to change the address from the default pin strap address to avoid conflict

Part Number: TPS546E25 When I write to VOUT_SCALE_LOOP (0x29) on TPS546E25 but the device NACKs and does not change value.

Part Number: AM62P K3 SoC (AM64x, AM62x...) have a set of One-Time Programmable (OTP) efuses which is anchoring Root-of-Trust (RoT) secure boot chain. Linux SDK supports the RSA key signed secure boot [1]. The FAQ discuss how to enable ECDSA key signed…

Other Parts Discussed in Thread: AM62P How can I access MAIN domain MCAN instances (MCAN0/MCAN1) from MCU domain cores (MCU R5F or M4F)?

Part Number: AM62L Other Parts Discussed in Thread: SYSCONFIG What are the steps to add the RTC driver and test the working in AM62L in MCU+SDK?

Part Number: MSPM0G3507 Use function of DL_Interrupt_registerInterrupt to define all the interrupts that used.(This function will copy the vector table into SRAM then modify the interrupt offset address and modify the interrupt ISR entry address as…

Part Number: MSPM0G3507 Use function of DL_Interrupt_registerInterrupt to define all the interrupts that used.(This function will copy the vectory table into SRAM and modify the interrupt ISR entry address as needed) Example: DL_Interrupt_registerInterrupt…

Part Number: PGA900 Other Parts Discussed in Thread: UNIFLASH I am trying to flash firmware to PGA900/970, and I am getting a data verification error. I have verified my hardware connection.

Part Number: AM6442 Is there a way to optimize the authentication time for AM64 and AM243 devices, as it is currently too large and is impacting the overall boot time?

Part Number: MSPM0-SDK To support diagnostic check for MSPM0 device, we suggest users start with CCS V20 which integrated by default. For the users with CCS V12.8.1, we need update the MSPM0 support package with 1.13 or newer. This forum share…