OMAP-L138: Debugging Issue

Waseem Ajmal

Part Number: OMAP-L138

Hi,

I am using OMAP-L138 LCDK. As it has no on board emulator, so I am using TMS320-XDS100v3 Emulator. Using this emulator, I have successfully build and launched my projects into target DSP for debugging session.

But suddenly, while launching debugging session, following error comes up:

I have tried and searched a lot to find solution. But could'nt found any. Kindly help me to solve this error.

Thanks

over 3 years ago

0 Ki over 3 years ago

TI__Guru**** 463561 points

Hello,

Please see the below link:

https://software-dl.ti.com/ccs/esd/documents/ccs_debugging_jtag_connectivity_issues.html#cable-break

A "cable break" indicates some issue with the connection between the probe and the target. A cable break "near" would mean the issue is somewhere closer to the debug probe side of the connection (like the pin or connector close to where the ribbon cable connects to the debug probe).

Please check the stability of your connections.

Thanks

Processors

Processors forum

OMAP-L138: Debugging Issue