It is not possible to use the Benchmark counter on a BIOS enabled application.

Krishna Allam

Hello!

Selecting Target->Clock->Enable yields the following error:

C28xx: Error programming AET Job: This task cannot be accomplished with the existing AET resources.

Can someone shed some light on this?

Additional Info:

CCS Version: CCSV4 ( Version: 4.2.1.00004 )

Target: TMS320F28335 (eZDSP from Spectrum Digital)

Emulators: XDS510 USB and XDS100v2

Thanks,
Krishna

0 Karl Wechsler over 14 years ago

You need to disable RTDX. RTDX and AET share resources. You can only use one or the other at one time. Not both.

Disable RTDX by first changing HST->LINKTYPE to "none" (or some such). And then disable RTDX. You can do this via gconf.

0 Krishna Allam over 14 years ago in reply to Karl Wechsler

Greetings Karl!

Thanks for the prompt reply...I am able to do the first half...that is:

Disable RTDX by first changing HST->LINKTYPE to "none" (or some such).

However, Disabling RTDX via gconf is not as obvious...I don't see a direct method to disable RTDX via TCF GUI.

I was expecting to see this under System->Global Settings...

Can you please elaborate?

Thanks,

Krishna

0 Karl Wechsler over 14 years ago in reply to Krishna Allam

Hi Krishna --

There's an RTDX module right above the HST module in the gconf GUI. Open it up and un-check the "Enable RTDX" box.

-Karl-

0 Krishna Allam over 14 years ago in reply to Karl Wechsler

Hi Karl...

Thanks! That worked! I should have looked a bit harder. :-) Regards, Krishna

Processors forum