Does DM3725 support booting from USB1 and USB2?

Gang Wu

Other Parts Discussed in Thread: DM3725

We have two USB ports, which connected to the USB1 and USB2 (not USB0) of DM3725.

Does DM3725 support booting from USB1 and USB2? We have two USB controller USB3320 for each ports. Thanks!

0 Michael T over 15 years ago

Gang:

No, USB peripheral boot requires a USB OTG port, which means only the HSUSB0 interface.

Regards,

Michael T

PS: Please mark this post as answered via the Verify Answer button below if you think it answers your question. Thanks!

0 Gang Wu over 15 years ago in reply to Michael T

Hi Michael,

Thanks! BTW, where is the Verify Answer button? I cannot get it.

Gang

0 Michael T over 15 years ago in reply to Gang Wu

Gang:

You might need to do "sign in" (upper right corner of this E2E Community Forum page) to see the button.

Let me know if you see it then.

Regards,

Michael T

PS: Please mark this post as answered via the Verify Answer button below if you think it answers your question. Thanks!

Processors forum