Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed the week of November 23.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TDA4VM: CPSW9G issue

Part Number: TDA4VM

Hi,TI:

1)The CPSW9G shown in the figure below is all RGMII interfaces?Does SGMII support?

2)The CSPW shown in the figure below is the SGMII interface,Does CSPW support both RGMIIand SGMII?

3)Cyscofig software is configured with 8 SGMII and 4 RGMII  interfaces. Are these 12 interfaces in cpsw? or only support  8 ports can be selected in cpsw?

Thanks!

Best Regards,

  • 1)The cspw9g shown in the figure below is all RGMII interfaces?Does SGMII support?

    CPSW9G supports both RGMII and SGMII. The interface used on each CPSW9G port is selected via CTRL_MMR pinmux registers.

    2)The CSPW shown in the figure below is the SGMII interface,Does CSPW support both RGMIIand SGMII?

    This diagram is for SGMII interface via SerDes. It is not applicable for RGMII.

    3)Cyscofig software is configured with 8 SGMII and 4 RGMII  interfaces. Are these 12 interfaces in cpsw? or only support  8 ports can be selected in cpsw?

    Each CPSW9G port can select the interface to be either RGMII or SGMII, not both at the same time. CPSW9G has 8 external ports.

  • :Each CPSW9G port can select the interface to be either RGMII or SGMII, not both at the same time. CPSW9G has 8 external ports.

    Can CPSW9G select 3 RGMII +1 RMII+ 4 SGMII interfaces?

  • Please help answer the following questions, thank you.