TDA4VM: In emmc+spl startup mode, how to control mcu1_0 fw to run at tcm or ddr.

you zhang

Prodigy 90 points

Part Number: TDA4VM

Hello,

In emmc+spl startup mode, how to control mcu1_0 fw to run at tcm or ddr?

we are use sdk 8.1, run the vision_apps demo.

thank you!!!

over 3 years ago

0 Brijesh Jadav over 3 years ago

TI__Guru**** 477995 points

Hi,

Are you planning to run vision apps on mcu1_0? Otherwise, mcu1_0 runs only sciserver and you could change linker command file to move section to tcm or ddr.

Regards,

Brijesh

Processors

Processors forum

TDA4VM: In emmc+spl startup mode, how to control mcu1_0 fw to run at tcm or ddr.