Other Parts Discussed in Thread: TMDSICE3359
I am new to the EtherCAT world. For my project I am going to purchase TMDSICE3359 boards. To bring up this board I was going through the documentations available on ti. The following are the steps that I followed,
- downloaded and installed PRU-ICSS-EtherCAT Slave binary for linux.
- downloaded and installed ti-processor-sdk-rtos-am335x-evm-06.03.00.106-Linux-x86-Install
- I have edited the projectCreate.sh script as per the starting guide document.
When I tried to run the script after this I got an error as follows,
What I am doing wrong here?