debugging Arm and DSP both

Hello Zhonghui,

You should be able to connect to both cores through CCS using the Blackhawk debugger and debug both cores at the same time. You'll need to make sure you get the right CCS version which supports OMAP5912. Please refer to this thread.

Regards,

Jianzhong

Hi Jianzhong,

Thank you for your help.

"I have another question which I think is related to the code composer.
When I made the DSP and the ARM core suspend and after I push run both the DSP and ARM9 core, they run and after few second the DSP is suspend again, like breakpoint but I didn't use breakpoint.
I will be happy for your help"

Best regards,

Hi Jianzhong,

Thank you for your help.

Is there any update?

Best regards,

Zhonghui,

Does your program have any interactions between the DSP and ARM9?

Regards,

Jianzhong

Hi Jianzhong,

Thank you for your help.

sorry about the delay.
the answer to the question is yes. if the ARM9 and DSP in interactions .

Best regards,

Hi Zhonghui,

If there are interactions between ARM9 and DSP, they may impact each other. Can you try to run just the DSP core but not the ARM9 core and see if it can run without being suspended?

Regards,

Jianzhong