TDA4VM: Compilation Error when trying to build IPC Echo

Mahesh kakani

Part Number: TDA4VM

Hi Team,

I am trying to generate binaries as per the 2. Getting Started — Processor SDK QNX J721E.

i have downloaded both RTOS and QNX from the links specified in the link above.

After following above link, i moved to 3. Build Steps — Processor SDK QNX J721E (ti.com) and followed the sequence of steps,

When i have initiated the make qnx_fs_create, i have faced below compilation error.

Can you please let me know is it problem with my code sequence?

Thanks in advance..
Mahesh

over 3 years ago

0 KB over 3 years ago

TI__Guru*** 127971 points

Hi Mahesh,

Error being seen is related to the installation of the QNX Screen Package. Please see below link, for a related issue.

https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1209436/tda4vm-question-about-the-version-of-the-qnx-screen-board-support-packages

Regards,

0 Mahesh kakani over 3 years ago in reply to KB

Prodigy 110 points

Hi KB,

Thanks for the response...

So as per the above link and comments from you., Do you have any inputs when QNX/BB will fix the issue? like whether they will be releasing another package which fixes the issue?

+1 KB over 3 years ago in reply to Mahesh kakani

TI__Guru*** 127971 points

Hi Mahesh,

The TI SDK is tested against a particular set of deliverables from QNX, the set of QNX deliverables that TI tests against is listed in the Release notes. Similarly QNX deliverables are tested against a particular TI SDK.

The issue being seen is that the TI SDK is expecting a folder path, that is only present Screen 3.2, Build ID 137 for J721E. This screen package is available upon request to QNX.

As per parallel thread please reach out to your local/remote QNX contact to get access to this package.

Regards,

Processors

Processors forum

TDA4VM: Compilation Error when trying to build IPC Echo