TDA4VM: How does vision-apps work in emmc boot mode?

youke yang

Part Number: TDA4VM

Hi,all

I read the user manual of vision-apps that it uses sd card to boot, and the write mode is also sd card

If I use emmc boot, how do I write vision-apps to test the vision-related routines? Is there any documentation on this?

my Version Information：ti-processor-sdk-linux-j7-evm-08_06_00_11-Linux-x86-Install.bin and ti-processor-sdk-rtos-j721e-evm-08_06_00_12.tar.gz

System Version：ubuntu-18.04

Board：Jacinto7 J721E EVM

Regards,

Youke

over 3 years ago

+1 Brijesh Jadav over 3 years ago

TI__Guru**** 499665 points

Hi Youke,

Vision apps uses the filesystem to read and/or to store the data. So as long as there is a valid filesystem available, even from eMMC, it will work fine. Please flash filesystem with test data in eMMC for vision apps demos to run fine.

Regards,

Brijesh

0 youke yang over 3 years ago in reply to Brijesh Jadav

Prodigy 100 points

Hi Brijesh，

Already started successfully in emmc, thanks.

Regards,

Youke

Processors

Processors forum

TDA4VM: How does vision-apps work in emmc boot mode?